ATSAM4S2BB-UUR More Semiconductors - ICs by Microchip Technology
| Status: | Active |
|---|---|
| Series: | ATSAM4S2B |
| RoHS: | Compliant |
Microchip's ARM®-based SAM4S2B microcontroller builds on the high-performance 32-bit Cortex®-M4 core.
The SAM4S2B features:
- Maximum operating speed of 120MHz
- 128KB of flash memory and 64KB of SRAM
- 1.62V to 3.6V supply
- Power consumption of 180uA/MHz in dynamic mode, below 25uA in RAM retention mode and 1uA at 1.8V in back-up mode with the RTC running
- Extensive peripheral set for connectivity, system control and analog interfacing
- Native support for Microchip QTouch capacitive touch technology for implementation of buttons, sliders and wheels
- Pin-to-pin compatible with Microchip SAM7S, SAM3N, SAM4N and SAM3S MCUs
- Pin-to-pin compatible with Microchip SAM7S, SAM3N and SAM3S MCUs
- Parallel Input/Output (IO) data capture mode
Features
| ARM Cortex-M4 running at up to 120 MHz |
| Memory Protection Unit (MPU) |
| DSP Instructions, Thumb®-2 instruction set |
| 128 Kbytes embedded Flash, ECC, Security Bit and Lock Bits |
| 64 Kbytes embedded SRAM |
| 16 Kbytes ROM with embedded boot loader routines (UART, USB) and IAP routines |
| Embedded voltage regulator for single-supply operation |
| Power-on-Reset (POR), Brown-out Detector (BOD) and Dual Watchdog for Safe Operation |
| Quartz or ceramic resonator oscillators: 3 to 20 MHz with clock failure detection and 32.768 kHz for RTT or system clock |
| RTC with Gregorian and Persian Calendar Mode, Waveform Generation in Backup mode |
| RTC counter calibration circuitry compensates for 32.768 kHz crystal frequency inaccuracy |
| High-precision 8/12 MHz factory-trimmed internal RC oscillator with 4 MHz default frequency for device startup, in-application trimming access for frequency adjustment |
| Slow clock internal RC oscillator as permanent low-power mode device clock |
| Two PLL up to 240 MHz for Device Clock and for USB |
| Temperature Sensor |
| Low-power tamper detection on two inputs, anti-tampering by immediate clear of general-purpose backup registers (GPBR) |
| 22 Peripheral DMA Controllers |
| Sleep, Wait and Backup modes; consumption down to 1 µA in Backup mode |
| 64-lead LQFP, 10 x 10 mm, pitch 0.5 mm |
| 64-lead QFN, 9 x 9 mm, pitch 0.5 mm |
| 64-lead WLCSP, 4.42 x 4.72 mm, pitch 0.4 mm |
| Revision A - Industrial (-40° C to +85° C), Revision B -(-40° C to +105° C) |
| USB 2.0 Device: 12 Mbps, 2668 byte FIFO, up to 8 bidirectional Endpoints, on-chip transceiver |
| Up to two USARTs with ISO7816, IrDA®, RS-485, SPI, Manchester and Modem Mode |
| Two 2-wire UARTs |
| Up to two 2-Wire Interface modules (I2C-compatible), one SPI, one Serial Synchronous Controller (I2S), one high-speed Multimedia Card Interface (SDIO/SD Card/MMC) |
| Two 3-channel 16-bit Timer Counters with capture, waveform, compare and PWM mode, Quadrature decoder logic and 2-bit Gray up/down counter for stepper motor |
| 4-channel 16-bit PWM with complementary output, fault input, 12-bit dead time generator counter for motor control |
| 32-bit Real-time Timer and RTC with calendar, alarm and 32 kHz trimming features |
| 256-bit General Purpose Backup Registers (GPBR) |
| 32-bit Cyclic Redundancy Check Calculation Unit (CRCCU) for data integrity check of off-/on-chip memories |
| 47 I/O Lines with external interrupt capability (edge or level sensitivity), debouncing, glitch filtering and on-die series resistor termination |
| Three 32-bit Parallel Input/Output Controllers, Peripheral DMA-assisted Parallel Capture mode |
| 16-channel, 1Msps ADC with differential input mode and programmable gain stage and auto calibration |
| One 2-channel 12-bit 1Msps DAC |
| One Analog Comparator with flexible input selection, selectable input hysteresis |
| Serial Wire/JTAG Debug Port(SWJ-DP) |
| Debug access to all memories and registers in the system, including Cortex-M4 register bank when the core is running, halted, or held in reset. |
| Serial Wire Debug Port (SW-DP) and Serial Wire JTAG Debug Port (SWJ-DP) debug access. |
| Flash Patch and Breakpoint (FPB) unit for implementing breakpoints and code patches. |
| Data Watchpoint and Trace (DWT) unit for implementing watchpoints, data tracing, and system profiling. |
| Instrumentation Trace Macrocell (ITM) for support of printf style debugging. |
| IEEE1149.1 JTAG Boundary-scan on all digital pins. |
| ASF-Atmel software Framework – SAM software development framework |
| Integrated in the Atmel Studio IDE with a graphical user interface or available as standalone for GCC, IAR compilers. |
| DMA support, Interrupt handlers Driver support |
| USB, TCP/IP, Wi-Fi and Bluetooth, Numerous USB classes, DHCP and Wi-Fi encryption Stacks |
| RTOS integration, FreeRTOS is a core component |
Specifications
| Part Family | ATSAM4S2B |
|---|---|
| CPU Type | Cortex-M4 |
| MaxSpeed (MHz) | 120 |
| Program Memory Size (KB) | 128 |
| SRAM (KB) | 64 |
| Data EEPROM (bytes) | 0 |
| Temp. Range Min. | -40 |
| Temp. Range Max. | 85 |
| Operation Voltage Min.(V) | 1.62 |
| Operation Voltage Max.(V) | 3.6 |
| Direct Memory Access (DMA) Channels | 22 |
| SPI™ | 3 |
| I2C | 2 |
| UART | 4 |
| I2S | 1 |
| Ethernet | None |
| SDIO/SD-CARD/eMMC | 1 |
| Quadrature Encoder Interface (QEI) | 1 |
| Crypto Engine | No |
| Number of USB Modules | 1 |
| USB Interface | Full Speed |
| Number of CAN Modules | 0 |
| Type of CAN module | None |
| ADC Channels | 10 |
| Max ADC Resolution (bits) | 12 |
| Max ADC Sampling Rate (ksps) | 1000 |
| Number of DACs | 1 |
| Input Capture | 12 |
| Standalone Output Compare/ Standard PWM | 0 |
| Motor Control PWM Channels | 0 |
| Max 16 Bit Digital Timers | 6 |
| Number of Comparators | 1 |
| Internal Oscillator | 4,8,12Mhz,32Khz |
| Hardware RTCC | Yes |
| Max I/O Pins | 47 |
| Pin Count | 64 |
| Low Power | No |
| Pins | Packaging | 64 | WLCSP |
| Temp Range | -40C to +85C |
| Packing Media | Tape and reel (5000) |
Last 6 months Inventory & Pricing History
Resources
Data Sheets |
|---|
| SAM4S Series Datasheet |
Design Checklist |
|---|
| Basic 32-Bit MCU Design and Troubleshooting Checklist |
Product Brief |
|---|
| Various Timers on SAM Devices Tech Brief |
Environmental Information
| JEDEC Indicator | e1 |
|---|---|
| ROHS | Compliant |
| China EFUP | Compliant |
| Device Weight (g) | 0.011 |
| Shipping Weight (kg) | 0.1992 |
| Lead Count | 64 |
| Package Type | WLCSP |
| Package Width or Size | 3.323x3.323x0.29mm |
| Soldering Composition | SAC405 |
Alternative Descriptions
| WLCSP,GREEN,IND TEMP,MRL B,T&R | Microchip Technology |
| 64Wlcsp, green, ind Temp, mrl B, t&r,128K Flash,64K Sram, 64 Wlcsp 3.323X3.323X0.29Mm T/R Rohs Compliant: Yes |Microchip Technology ATSAM4S2BB-UUR | Newark Electronics |
Frequently Asked Questions
Where can I find additional details, specifications and documents for a ATSAM4S2BB-UUR?
Additional datasheets, footprints and schematics for ATSAM4S2BB-UUR are listed on our Part Details page. You can also find images and similar parts to ATSAM4S2BB-UUR on this page.
What pricing and inventory information can I view?
Distributor pricing and stock information is available for ATSAM4S2BB-UUR on our Product Comparison page. Access via the 'View Pricing & Stock' button to view ATSAM4S2BB-UUR price breaks, MOQs, lead times, inventory and SKUs from distributors.
What category does ATSAM4S2BB-UUR fall under?
The ATSAM4S2BB-UUR is listed under Semiconductors - ICs > More Semiconductors - ICs.
Can I view similar or alternative parts?
You can view similar parts to ATSAM4S2BB-UUR when available in the More Semiconductors - ICs range under the specifications section at the bottom of the details page.
Who can I contact for technical support of the product?
Submit any questions directly to the customer support team of the distributor listing the product. For the ATSAM4S2BB-UUR you can contact the distributor directly for product support, shipping queries etc.
Is the ATSAM4S2BB-UUR RoHS compliant?
Yes. This part has been flagged as RoHS Compliant by Microchip Technology.
Which authorised distributors for ATSAM4S2BB-UUR have stock available?
Authorised distributors including Microchip Technology, Newark Electronics and EBV Elektronik have stock available or on a lead time for ATSAM4S2BB-UUR.
How do I check stock and lead times for all distributors?
Stock availability and lead times will be displayed for ATSAM4S2BB-UUR often in real-time on the comparison pages.
What if I can't find stock of ATSAM4S2BB-UUR?
You can fill out our help required form which you can use to request a quote for ATSAM4S2BB-UUR from some of our verified obsolescence suppliers. Alternatively, contact us via our web chat in the bottom left of your screen and one of our team will try to help.